Investigating the complex phase behavior and drug release of ternary solid dispersions based on ethyl cellulose

18 December 2020 in Research Highlights 302 hits

In this work, the insoluble hydrophobic polymer ethyl cellulose (EC) was investigated as a potential carrier for the formulation of…

Development of a surface coating technique with predictive value for bead coating in the manufacturing of amorphous solid dispersions

05 October 2020 in Research Highlights 975 hits

The aim of this research was to investigate whether a surface coating technique could be developed that can predict the…

Stabilization of amorphous drugs; are crystalline inorganic excipients a way forward?

24 August 2020 in Research Highlights 1908 hits

Physical instability arguably is the major challenge in using neat amorphous active pharmaceutical ingredients in everyday tablets and capsules [1].…

Effect of particle size and deformation behaviour on water ingress into tablets

22 July 2020 in Research Highlights 1860 hits

Check out this commented presentation by Anne Linnet Skelbæk-Pedersen

Machine-Vision-Enabled Salt Dissolution Analysis

19 July 2020 in Research Highlights 1786 hits

Here's a commented presentation from Jerneij Stukelj from the University of Helsinki, Finland.


21 April 2020 in Research Highlights 2924 hits

Pharmaceutics (ISSN 1999-4923, click here) is an open access journal which provides an advanced forum for the science and technology…

Cryomilling as manufacturing technique to produce ASDs, a technique as gentle as generally assumed or rather not?

06 January 2020 in Research Highlights 4313 hits

Abstract In this short communication, on current hot topics in the drug delivery and disposition lab, a chemical (and physical)…

Influence of the Suspension Composition on the Mechanical Strength of Dried Microspheres

10 September 2018 in Research Highlights 10211 hits

Spray drying is widely used in pharmaceutical manufacturing to produce microspheres from solutions or suspensions. The mechanical properties of the…

Novel stand-alone test tool for scientific qualification of a dosator capsule filling process

10 September 2018 in Research Highlights 11138 hits

One of the biggest problems in the manufacturing of high-quality low-dose inhalation products, is dose uniformity of filled capsules [1].…